Attaching The Appliance In The Cavity; Connecting The Water To The Appliance - Thermador T18BF Serie Instrucciones De Instalación

̈
Before attaching the appliance in the cavity, check
– that the top and sides of the frame are situated on
the cavity front,
– that the finger guard functions by opening and
closing the door several times.

11. Attaching the appliance in the cavity

̈
Open the appliance door.
̈
Pull finger guard all the way out of the gap between the
appliance and cavity wall.
̈
Screw the frame to the cavity wall through the gap
between the door and carcass (2 x 4 screws).
̈
Push the finger guard through the frame recess into the
gap between the appliance and cavity wall.
24
12. Connecting the water to the
appliance
m
CAUTION
When bending the water pipe, do not kink it, otherwise
there is a risk of leaks and water damage.
NOTE
When connecting the water pipe to the solenoid valve
of the appliance, follow the instructions supplied by the
manufacturer of the ice maker installation kit enclosed
with the installation manual.
̈
Remove the cap from the appliance connection (1.).
̈
Bend the water pipe according to the location of the
connection on the appliance (2.).
̈
Push the union nut and seal onto the water pipe.
̈
Push the end of the water pipe into the appliance
connection and screw on the union nut (3.).
Tighten hand-tight.
̈
Using the open-ended wrench, tighten the union nut.
Do not overturn!
̈
Open the shut-off valve and main water tap. Check the
connection on the shut-off valve and on the appliance
for leaks.
m