Required Accessories And Tools; Supplied Accessories; Optional Accessories; Other Required Accessories From Specialist Outlets - Thermador T18BF Serie Instrucciones De Instalación

Required accessories and tools

Supplied accessories

– Installation instructions
– Operating instructions
– Installation kit

Optional accessories

Extreme Combination Side-by-Side Heating kit
If the gap between the appliances is less than 6" (160 mm).
Other required accessories from
specialist outlets
Ice maker installation kit
For connecting appliances which require water, e.g. for an
ice maker.
Maximum outer diameter of the water pipe
(without fittings):

Tools

– Cordless screwdriver T20
– Torx screwdriver T20
– Torx bit T20 + magnetic holder
5
– / " (8 mm) hex nut driver
16
– Wood drills in different sizes
1
– Open end wrench /
– Multigrip pliers
– Adjustable wrench
– Cutter with adjustable blade
– Metal tape measure
– Square
– Spirit level length 2' (60 cm) and 4' (1,2 m)
– Marking-out level, length at least 4' (1.2 m) for individual
appliances or 7' (2.0 m) for Side-by-Side installation
16
1
/ " OD copper line
4
13
/ " (10 mm).
32
" (SW 13 mm)
2

Other

– Stepladder
– Dolly, hand truck
– Hammer drill for drilling holes in wall or floor
– Bits according suitable for material and in different sizes
– Wooden beam (cross section min. 3" x 4" (75 cm x 100
cm) as an alternative tilt protection, length according to
the width of the installation cavity
– Wooden screws in different sizes
1
– Thin (max. / " (1.5 mm)), suitable material to protect
16
the floor from damage (e.g. lino)
– Suitable material for covering and protecting furniture
(e.g. protective sheets)
– Adhesive tape
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
NOTE