Ating Data; Perating Conditions; Orking Instructions; On/Off - SUHNER ABRASIVE TURBO TRIM SH 1300 Documentación Técnica

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Remove the blade housing by drawing it towards.
Detach the blade from the blade housing. To connect
the blade, follow the above instructions in reverse order.
Tighten the screws with max. 1.5 Nm. After connecting,
press the grease cup button two to three times.
Very sharp blade!
2.1.3 c
/
Onnecting
detAching the depth gAuge
Position the depth gauge in the blade housing. Secure/
release the depth gauge at the two screws.
Turn the setscrew to set the cutting depth.
Very sharp blade!
2.2 r

Ating dAtA

Blade diameter
Maximum speed
Vibration
Weight
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure.
Loosening up your arms and hands at regular intervals
prevents muscle tenseness from adversely affecting your
health.
2.3 O

perAting cOnditiOns

Temperature range during operation: -7 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
andling
3.1 w

Orking instructiOns

Focus on an ergonomic stance and movements when
working with the tool. You should always stretch out the
thumb of the hand holding the hand piece. When work-
ing in sweeps or one continuous pass, keep the surface
of the blade as flat as possible on the surface you are
working. For maximum working efficiency we recommend
keeping replacement blades ready at all times.
During operations the tool must be lubricated reg-
ularly from the grease cup!
For any further questions on efficient working,
please contact the area representative or the manufac-
turer.
3.2 s

On/Off

witching
Switching ON/OFF is described in the technical
document ROTO TT.
Very sharp blade!
131mm
-1
675min
2
≤2.5m/s
450kg
/o
peration
19

Publicidad

Tabla de contenido
loading

Tabla de contenido