SOMFY ROLLIXO RTS Manual De Instalación página 12

Rollixo RTS
> Optical wired safety edge - Dipswitch 4 receiver set at OFF
Dipswitch 4 receiver position
If a wired safety edge replaces a radio safety edge, the radio safety
edge transmitter must be cleared (see section 13) to ensure the
wired safety edge is taken into account.
> Wired 8k2 resistive safety edge - Dipswitch 8k2 4 receiver set
to ON
Dipswitch 4 receiver position
If a wired safety edge replaces a radio safety edge, the radio safety
edge transmitter must be cleared (see section 13) to ensure the
wired safety edge is taken into account.
> Orange LED (part no. 9017842)
ge
9
4 W max.
10
Stop Safety Edge
KeySwitch
Sec
5 6 7 8 9 10 11
Stop Safety Edge KeySwitch
Sec
5 6 7 8 9 10
KeySwitch Flash 24V dc 24V C
10 11 12 13 14 15 16 17
> Key lock
Successive presses cause the motor to move (initial position: door closed) as
per the following cycle: open, stop, close, stop, open, etc.
1
> Alarm
It is essential to have programmed at least one remote control. The
alarm can only be stopped with a memorised remote control.
Installing and connecting the alarm
Mount the alarm to the receiver with the bolt provided.
Connect the alarm connector.
Activating/Deactivating the alarm
To activate/deactivate the alarm, simultaneously press the
The alarm emits a beep if it has been activated.
1 2
STOP
11 1
Alarm operation
The alarm is triggered for 2 minutes if the door is raised manually.
No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it. The alarm can only be stopped with a memorised remote
control.
Alarm operation test
Simultaneously press then quickly release the
receiver.
1
STOP
Safety Edge
KeySwitch Flash
Sec
7 8 9 10 11 12 13
1
STOP
3 4
Prog
and
STOP
2 3 4
Prog
Copyright © 2014 Somfy SAS. All rights reserved.
24V
14 1
and buttons
STOP
2 3 4
Prog
buttons on the