Installing A Resistive Radio Safety Edge With Ese Transmitter; Installing Magnets On The Runner; Installing The Resistive Safety Edge And Its Ese Transmitter - SOMFY ROLLIXO RTS Manual De Instalación

Rollixo RTS
Indicator light 2 on the receiver goes out and the receiver Prog
the time required for the transmitter and receiver to communicate with
each other).
The transmitter is memorised in the receiver.
1 2 3 4
STOP Prog
4s
1 2 3 4
STOP Prog
[3]. Optional: the base magnet must be installed if the ground is uneven and
causes erratic obstacle detection.
Press the button to move the garage door to the bottom position, then
secure the base magnet to the edge of the runner, positioning it in line
with the transmitter.
Move SW3 dipswitch 1 on the transmitter to ON.
This operation is important. Ensure the alignment is observed.
6 - INSTALLING A RESISTIVE RADIO
SAFETY EDGE WITH ESE TRANSMITTER

6.1 Installing magnets on the runner

To function correctly, this solution requires a set of magnets to be installed on
the runner.
Copyright © 2014 Somfy SAS. All rights reserved.
1 2 3 4
STOP Prog
1 2 3 4
Prog
STOP
10 mm maxi.
BASE
magnet
ON
1 2 3 4
UPPER magnet
Safety edge
transmitter
mounting plate
BASE magnet
[1]. Press button to position the garage door in the upper position.
1 2 3 4
Prog
STOP
[2]. Fix the upper magnet to the edge of the runner observing a distance of
70 mm between the base of the transmitter and the top of the magnet.
This operation is important. Ensure the dimensions are observed.
[3]. Press button to position the garage door in the low position.
1 2 3 4
STOP Prog
[4]. Attach the magnet to the edge of the runner, positioning it in line with the
transmitter.
This operation is important. Ensure the dimensions are observed.
[5]. Press button then stop the door by pressing button
garage door in the intermediate position.
1 2 3 4
STOP Prog
6.2 Installing the resistive safety edge and its ESE
transmitter
Follow the instructions provided with the ESE transmitter and the resistive
safety edge lengthening kit.
10 mm maxi.
70 mm
UPPER
magnet
10 mm maxi.
BASE
magnet
to position the
STOP
STOP
7