Failure Display And Inspection - EAS ELECTRIC EMIH320-3F Manual De Instrucciones

The induction hob
makes a low humming
noise when used on
a high heat setting.
Fan noise
coming from the
induction hob.
Pans do not
become hot and
appears in the
display.
The induction hob or a
cooking zone has turned
itself off unexpectedly,
a tone sounds and an
error code is displayed
(typically alternating
with one or two digits in
the cooking timer
display).

8. Failure Display and Inspection

The induction hob is equipped with a self diagnostic function. With
this test the technician is able to check the function of several
components without disassembling or dismounting the hob from the
working surface.
Failure
code
Supply voltage is above the
rated voltage.
E1
Supply voltage is below the
rated voltage.
E2
This is caused by the
technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue
to run even after you've
turned the induction hob off.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small
for the cooking zone or not
properly centred on it.
Technical fault.
Problem
Auto-Recovery
This is normal, but the noise
should quieten down or
disappear completely when you
decrease the heat setting.
This is normal and needs no
action. Do not switch the power
to the induction hob off at the
wall while the fan is running.
Use cookware suitable for
induction cooking. See section
'Choosing the right cookware'.
Centre the pan and make sure
that its base matches the size
of the cooking zone.
Please note down the
error letters and numbers,
switch the power to the
induction hob off at the
wall, and contact a
qualified technician.
Please inspect whether
power supply is normal.
Power on after the power
supply is normal.
23
Solution
V.2