Care & Cleaning; Self-Clean Oven - Maytag T2 Guía Del Usario

Ocultar thumbs Ver también para T2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care & Cleaning
Self–Clean Oven
CAUTION:
➢ It is normal for parts of the range to
become hot during a clean cycle
➢ Avoid touching cooktop, door, win-
dow, or oven vent area during a
clean cycle.
➢ To prevent damage to oven door,
do not attempt to open the door
when the LOCK indicator word is
displayed.
➢ Do not use commercial oven
cleaners on the self-clean oven fin-
ish or around any part of the oven
as they will damage the finish or
parts.
The self-clean cycle uses above normal
cooking temperatures to automatically
clean the entire oven interior.
It is normal for excessive flare-ups, smoking
and flaming to occur during cleaning if the
oven is heavily soiled. It is better to clean
the oven regularly rather than to wait until
there is a heavy build-up of soil in the oven.
During the cleaning process, the kitchen
should be well ventilated to help eliminate
normal odors associated with cleaning.
The cleaning time can be varied depending
on the amount of soil. Press the appropri-
ate number pads to set any amount of time
between two and four hours. "2:00" hours of
cleaning for light soil, up to "4:00" hours of
cleaning for heavy soil.
BEFORE SELF-CLEANING
Turn off the oven light before cleaning as the
light may burn out during the clean cycle.
Remove broiler pan, all pans and the oven
racks from the oven. The oven racks will
discolor and may not slide easily after a
self-clean cycle.
Clean oven frame,
door frame (area
outside the door
gasket) and around
the opening in the
door gasket with a
nonabrasive cleaning agent such as Bon
13
Ami* or detergent and water. These areas
are not exposed to cleaning temperatures
and should be cleaned to prevent soil from
baking on during the clean cycle.
To prevent damage, do not clean or rub
the gasket around the oven door. The gas-
ket is designed to seal in heat during the
clean cycle.
Wipe up excess grease or spillovers from the
oven bottom to prevent excessive smoking,
flare-ups or flaming during the clean cycle.
Wipe up sugary and acidic spillovers such as
sweet potatoes, tomato or milk-based
sauces. Porcelain enamel is acid resistant,
not acid proof. The porcelain finish may
discolor if acidic spills are not wiped up
prior to a self-clean cycle.
SETTING THE CONTROLS
FOR SELF-CLEAN
1. Close oven door.
2. Press Clean pad.
➢ CLEAN will flash and "—:—" will light
in the display.
➢ If door has not been closed, "door" will
light in the display and a signal will
beep until the door is closed and the
Clean pad is pressed again.
3. Press Preset (0) pad for "3:00" hours of
cleaning time for an average soiled oven.
Or, press the appropriate number pads
for the desired cleaning time between
two and four hours.
4. Four seconds after entering the cleaning
time, the oven door will automatically
lock.
➢ LOCK will appear in the display.
➢ CLEAN symbol
the display.
°
0 0 0
03:00
HR
BAKE
LOCK
DELAY COOK STOP TIMER
CLEAN
ROAST BROIL
5. When the cleaning time has been com-
pleted, the indicator word CLEAN will
3 5 0
turn off. The indicator word LOCK will
remain on until the oven has cooled
(approx. 1 hour).
°
3 5 0
10
:00
HR
BAKE
LOCK
DELAY COOK STOP TIMER CLEAN ROAST BROIL
LOCK IS STILL ENGAGED.
DOOR CANNOT BE
OPENED UNTIL LOCK IS
NO LONGER DISPLAYED.
When the oven has cooled, the indicator
word LOCK will turn off and the door will
automatically unlock.
TO CANCEL SELF-CLEAN CYCLE:
➢ Press CANCEL pad.
➢ If the indicator word LOCK is NOT dis-
played, open oven door. If LOCK is dis-
played, allow oven to cool, then open
oven door.
NOTE: Depending on the length of time
the oven had been cleaning, it may take
up to an hour for the oven to cool down.
When the oven is cool, the door will auto-
matically unlock and can be opened.
IF YOU WISH TO DELAY THE START OF
CLEANING:
1-3. Follow preceding steps 1-3.
4. Press the Stop Time pad.
➢ Stop Time will flash in the display and
display will show calculated stop time
based on the current time of day and
the clean time previously entered.
5. Press the appropriate number pads to
enter the time you wish the oven to stop.
A stop time can only be accepted for later
in the day.
EXAMPLE: If at 9:00 you set the oven to
clean for three hours, the calculated stop
time would be "12:00".
➢ If you want the stop time to be 1:00,
press the number pads "1,0,0". Four
seconds later, the display will show
will appear in
1:00 and the indicator word DELAY.
6. When the oven begins to clean, the
CLEAN symbol will light and DELAY will
go off in the display.
7. When the clean time has been complet-
ed, the indicator word CLEAN will turn
off. The indicator word LOCK will remain
on until the oven has cooled. When the
oven has cooled, the indicator word
LOCK will turn off and the door will auto-
matically unlock.

Publicidad

Tabla de contenido
loading

Tabla de contenido