Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Active Location of Utilities
Locating with the Receiver
1. Turn the Receiver on by pressing the
power button for two seconds. Hold the
Receiver vertically.
2. Press
repeatedly until 33 kHz is
selected.
3. Follow the steps as described in
"Locating with the Receiver"
the arrow indicators to quickly assess the
location of the wire (optionally, measure the
depth of the wire – refer to the User Manual
for more details).
(Pg 2-4), using
500
©2018 Amprobe
For detailed specifications and ordering go to amprobe.com 6011239 B
®
Note: For better accuracy, move the Transmitter
directly over the location of the utility after its
detection.
Note: If the arrows indicate a different target
position than the largest bar graph reading,
signal distortion is present. Use the bar graph
to pinpoint the line as it is influenced less than
the arrows in a distorted signal field.
Quick Guide
7
Publicidad
Tabla de contenido
