DeVilbiss DAGR Manual De Instrucciones Y Mantenimiento página 8

Page 8 SB-2-056
the following hazards may occur
during the normal use of this
equipment. Please read the following
warnings before using
equipment.
hAZArd: Fire
cAuSe: Solvent and coatings can be highly
flammable or combustible especially when
sprayed.
SAFeGuArdS: Adequate exhaust must be
provided to keep air free of accumulations of
flammable vapors.
Smoking must never be allowed in the
spray area.
Fire extinguishing equipment must be
present in the spray area.
hAZArd: SoLVent SPrAY
this
CAUSE: During use and while cleaning and
flushing, solvents can be forcefully expelled
from fluid and air passages. Some solvents
can cause eye injury.
SAFeGuArdS: Wear eye protection.
hAZArd: inhALinG toxic SuBStAnceS
cAuSe: Certain materials may be harmful if
inhaled, or if there is contact with the skin.
SAFeGuArdS: Follow the requirements of
the Material Safety Data Sheet supplied by
your coating material manufacturer.
Adequate exhaust must be provided to keep
the air free of accumulations of toxic
materials.
Use a mask or respirator whenever there is a
chance of inhaling sprayed materials. The
mask must be compatible with the material
being sprayed and its
Equipment must be as prescribed by an
industrial hygienist or safety expert, and be
NIOSH approved.
hAZArd: exPLoSion hAZArd –
incoMPAtiBLe MAteriALS
cAuSe: Halogenated hydrocarbon solvents –
for example; methylene chloride and 1,1,1, –
Trichloroethane are not
compatible with the aluminum that might be
used in many system components. The
chemical reaction caused by these solvents
reacting with aluminum can become violent
and lead to an equipment explosion.
SAFeGuArdS: Guns with stainless steel
internal passageways may be used with
concentration.
chemically