Assembly - Attaching The Fan Blades; Attaching The Blades To The Blade Brackets - Home Decorators Collection 51715 Guía De Uso Y Cuidado

Assembly - Attaching the Fan Blades

1
Fastening the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation, including an alignment post and
captive blade bracket screws.
□
Fasten the blade brackets (G) to the fan-motor assembly (E) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket screws (PP).
□
Repeat this step for the remaining blade brackets.
2
Attaching the blades to the blade
brackets
□
Mount the fan blade (H) to the blade bracket (G) by aligning the
three key-slot holes in the blade (H) with the three posts on the
top of the blade bracket (G).
□
Hold the blade (H) with both hands close to the blade bracket
(G) and press down firmly. Ensure the key-slot holes are
properly seated on the blade bracket (G) posts.
□
While still holding the blade (H) down with both hands, slide
the blade (H) until it engages in the locking mechanism (QQ).
Make sure the locking mechanism (QQ) at the rear of the blade
bracket (G) springs upward and butts against the edge of the
blade (H), indicating a secure connection.
□
Visually inspect the top of the blade bracket (G) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (H).
E
H
G
QQ
12
E
PP
G