Assembly - Attaching The Fan Blades; Attaching The Blades To The Blade Brackets - Home Decorators Collection MAKENNA 52106 Guía De Uso Y Mantenimiento

Ventilador de techo de 1.52 m (60 plg)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Attaching the Fan Blades

1
Attaching the blades to
the blade brackets
Attach a blade (G) to the blade arm (F) by aligning the holes
on the blade arm bracket (H) with the holes on blades (G) and
blade arms (F), inserting the screws (AA) into the holes in the
blade arm (F) and through the blade (G), blade arm (F) and
blade arm bracket (H).
Tighten each screw to secure the blade (G).
Repeat this step for each blade (G), blade arm (F) and blade
arm bracket (H).
2
Attaching the blade assemblies
to the motor
NOTE: Only attach 7 of the 8 blade assemblies to the fan
motor. This will make it easier to lift and hang the fan
assembly. The final blade will be attached after hanging
and wiring the fan.
Attach the blade assembly to the motor assembly (E) by
aligning the screw holes on the blade arm (F) with the screw
holes on the bottom of the fan motor assembly (E).
Insert the screws (EE) into the holes on the blade arm (F) and
through the holes on the bottom of the fan motor assembly (E),
and start the screws in each hole. Do not completely tighten
these screws. The blade arms should be slightly loose when
attaching the decorative frames.
Repeat this process for 6 of the 7 remaining blade assemblies.
3
Assembling the decorative frame
NOTE: Only attach 7 of the 8 decorative frame pieces to
the blade assemblies. The final decorative frame piece
will be attached after the last blade assembly is attached.
Attach the decorative frame (I) to the blade assembly by aligning
the two posts of the decorative frame with the two holes in
the blade. Secure the decorative frame to the blade using the
decorative frame screws (FF). Insert the decorative frame
screws (FF) through the two holes in the blade arm (F) and
screw them into the posts of the decorative frame (I). Align the
hole in the tab at the end of the decorative frame (I) with the
frame brace on the side edge of the blade arm (F) and secure
using a frame brace screw (GG). Make sure all screws are
completely tightened.
Repeat this process for 6 of the 7 remaining decorative frame
pieces (I).
G
H
7
Please contact 1-800-986-3460 for further assistance.
AA
F
E
F
EE
GG
FF
FF
I
F
HOMEDEPOT.COM/HOMEDECORATORS

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1005 819 928

Tabla de contenido