Assembly - Attaching The Fan Blades; Attaching The Blades - Home Decorators Collection 51560 Guía De Uso Y Cuidado

Assembly - Attaching the Fan Blades

1
Attaching the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick and
easy blade installation, including an alignment post and captive
blade bracket screws.
□
Please note the captive blade bracket screws, are pre-attached
into the blade bracket (F).
□
Fasten the blade bracket (F) to the motor (E) by inserting the
alignment post into the slot on the bottom of the fan-motor
assembly (E) and tightening the motor screws (SS).
□
Repeat for the remaining four blade brackets (F).
2

Attaching the blades

NOTE: The blades must be installed before attempting to operate
the fan. If the blades are not installed, the motor will not function
properly.
NOTE: Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
□
Mount the fan blades (G) to the blade bracket (F) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (F).
□
Hold the blade (G) with both hands close to the blade bracket
(F) and press the blade (G) down firmly. Ensure the key-slot
holes are properly seated on the blade arm posts.
□
While still holding the blade (G) down with both hands, firmly
slide the blade (G) away from the fan-motor assembly (E) until
the blade (G) engages in the locking mechanism. Make sure
the steel locking mechanism at the rear of the blade bracket
(H) springs upward and snaps into place against the edge of
the blade (G) indicating a secure connection.
□
Visually inspect the top of the blade bracket (F) to ensure the
locking mechanism is securely in place.
□
Repeat for the remaining blades (G).
11
Please contact 1-800-986-3460 for further assistance.
E
F
SS
E
G
F
HOMEDEPOT.COM/HOMEDECORATORS