HP LaserJet 1320nw Manual Del Usario página 27

Ocultar thumbs Ver también para LaserJet 1320nw:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

e. On the network configuration page, confirm that there is a Network Name (SSID),
2. Preparing your computer
a. Unplug any network cable connected to your computer. This will disable any wired
b. In the configuration properties for your computer's wireless network card, verify that
c. Ensure that your computer has an automatic IP address before starting the software
3. Installing the Software
a. Insert the software CD into your computer's CD-ROM drive. Start the software
b. If one or more printers are found and displayed on the Printers Found page, select
c. HP highly recommends that you select Change Settings on the Confirm Settings
d. Accept the settings on the Confirm Settings page.
e. Continue with the installation until the process is complete.
f.
ENWW
such as hpsetup.
network. Only the wireless network should be active during the installation. To verify
that your wired network is disabled, click Start, Control Panel, and Network
Connections. (The unplugged cables should be reconnected after the installation is
complete.)
the hpsetup network is available and connect to it. (For example, in Windows XP, to
connect to the hpsetup wireless network, click Start, Control Panel, Network
Connections, and Wireless Network Connection. Then click Properties and
select the Wireless Networks tab. In the Available networks box, select hpsetup
and click Configure. Click OK. The network name, hpsetup, should now be
available in the Preferred networks section. Click Refresh if the hpsetup network
is not listed.) If you are using a wireless card or wireless adapter, use the utility that
came with your wireless card or wireless adapter to add hpsetup to your network
options. The network name, hpsetup, should only be used to configure the printer.
installation. Your computer may take a few moments to acquire an automatic IP
address. (For example, in Windows XP, to check whether your computer has an
automatic IP address, click Start, All programs, Connect To or click Start,
Connect To and Show all connections. Then select Wireless Network
Connection. In the Details section, verify that the IP address is of the form
169.254.x.y, where x and y are any numbers between 0 and 255.) Also, verify that
the peer-to-peer network name is hpsetup. If the computer has not yet acquired a
valid automatic IP address, wait a few minutes. The Details section of the Network
Connections box will change to show the new IP address when it is valid. Now you
are ready to start the software installation.
installation, and follow the on-screen instructions.
the printer that has the same IP address as the one you are installing, and then click
Next.
page to configure your device's network to match the settings of the existing ad hoc
network on your computer. If you do not have an existing ad hoc network, then
accept the default settings.
After the software installation is complete and your computer has been rebooted,
reconnect any network cables that you may have unplugged during the installation.
Connect the printer to a wireless network
21

Publicidad

Tabla de contenido
loading

Tabla de contenido