Operation Instructions; Checking For Leaks - Dyna-Glo DGP397SNP Manual De Instrucciones

OPERATION INSTRUCTIONS

CHECKING FOR LEAKS

and regulator for leaks with a water and soap solution.
• Always perform leak test prior to lighting the grill.
• Do not smoke while testing for a leak.
• Always perform leak tests outdoors in a well-ventilated area.
• Do not use the grill until any and all leaks are corrected.
• If you are unable to correct a leak, disconnect the propane supply and call a gas appliance service
dealer.
PERFORM LEAK TEST
Put leak test solution in a spray bottle.
• Ensure all control knobs are in the
• Connect the gas hose to the gas supply.
• Open the LP gas tank valve.
of applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the
gas supply valve immediately and repair or replace the defective part. Do not use the grill until
all leaks are corrected.
our customer service center. Do not use replacement parts that are not intended for this grill.
ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO
PREVENT FIRE, DAMAGE AND/OR INJURY.
O
OFF position.
CAUTION
WARNING
18
If a replacement is necessary, please call