KTM Power Parts 60312992044 Manual Del Usuario página 6

23
22
24
6
1
5
2
9
16
14
15
18
23
17
- Remove the screw (22) .
- Drill a Ø5 mm hole in the cockpit holder (23).
- Mount the retaining bracket (16) using the original screw (24).
- Loosen the screw (5).
- Position the preassembled GPS bracket (1) with the right foot (17) and
left foot (18) on the cockpit holder (23) at the desired angle.
- To set the angle of the braces, release the screw (3) and pull the feet slightly
out of their fixture.
- Mount and tighten the bushing (14) and EJOT screw (15) on the left and
right.
- Position the nut (2) and mount and tighten the screw (3).
Mechanism
- To adjust the angle, pull the support (9) to the left, set the desired angle,
and release the support.
Final steps
- Mount the navigation device using the screws (12) and nuts (13).
- Mount the bracket (21), left windshield holder (20), and windshield.