Klarstein 10031432 Manual Del Usuario página 59

Phenomenon
Indoor unit cannot receive
remote control signal or re-
mote control has no action.
Air conditioner does not oper-
ate
Mist is emitted from indoor
unit' s air outlet.
No air emitted from indoor
unit.
Set temperature can't be
adjusted.
59
Check items
Fluorescent lamp in room?
Power failure?
Is plug loose?
Air switch trips off or fuse is
Wiring has malfunction
Unit has restarted immediately
after stopping operation.
Whether the function setting for
remote control is correct.
Indoor temperature and humid-
ity is high?
Is the air inlet or air outlet of
indoor unit is blocked?
Has the indoor temperature
reached the set temperature (in
heating mode)?
Has the heating mode been
turned on just now?
Is the unit is operating under
auto mode?
Your required temperature
exceeds the set temperature
range?
Solution
Take the remote control
close to indoor unit.
Turn off the fluorescent lamp and
then try it again.
Wait until power recovery.
Reinsert the plug.
Ask a professional to replace air
switch or fuse.
Wait for 3min, and then turn
on the unit again.
Reset the function.
Because indoor air is cooled rap-
idly. After a while, indoor tem-
perature and humidity will be
decrease and mist will disappear.
Eliminate obstacles.
After reaching to set tempera-
ture, indoor unit will stop blowing
out air.
In order to prevent blowing out
cold air, indoor unit will be started
after delaying for several minutes,
which is a normal phenomenon.
Temperature can't be adjusted
under auto mode. Please switch
the operation mode if you need
to adjust the temperature.
Set temperature range:
16 °C~30 °C.