Installation Of Outdoor Unit - Klarstein 10031432 Manual Del Usuario

Installation of outdoor unit

Step 1: fix the support of outdoor unit
1. Select installation location according to the house structure.
2. Fix the support of outdoor unit on the selected location with expansion screws.
Note
• Take sufficient protective measures when installing the outdoor unit.
• Make sure the support can withstand at least four times the unit
weight.
• The outdoor unit should be installed at least 3cm above the floor in
order to install drain joint.
• For the unit with cooling capacity of 2300W~ 5000W, 6 expansion
screws are needed; for the unit with cooling capacity of 6000W~
8000W, 8 expansion screws are needed; for the unit with cooling
capacity of 10000W~16000W, 10 expansion screws are needed.
Step 2: install drain joint (only for cooling and heating unit)
1. Connect the outdoor drain joint into the hole on
the chassis, as shown in the picture below.
2. Connect the drain hose into the drain vent.
Step 3: fix outdoor unit
1. Place the outdoor unit on the support.
2. Fix the foot holes of outdoor unit with bolts.
79
at least 3cm above the floor
drain vent
outdoor drain joint
Drain hose
foot holes
foot holes
chassis