Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Attach plastic studs
Plastic studs attached
with 4 short screws
Visible side
Using a
/
" nut driver, attach the 4 plastic studs to the
5
16
wooden panel using the four 10-16 x
screws provided.
6.
Attach custom panel
Align the studs on the custom wood panel to the keyhole
slots on the door assembly. Ensure that all 4 plastic studs are
engaged in the keyhole slots. Slide wood panel down until the
top surface of the wooden panel is flush with the top of the door.
/
" hex-head (short)
5
8
Wooden panel
assembly
7.
Align top edges of panel to door
Customer-
supplied panel
Remove 2 short screws
and replace with long
screws provided.
Open the door and align top edges. Use tape to mark a
bit to gauge the hole depth of approximately 1
pilot holes into the top corners of the door using hole in liner as
a guide.
Phillips screwdriver
8.
Install custom panel
Customer
supplied panel
Using a 6-lobe screwdriver, (or Phillips screwdriver or
driver with the 6-lobe adapter), install two 8-18 x 1
screws in top corners to secure custom wood panel in place.
Align
top edges
Drill
through
these holes.
/
" drill
3
32
/
" (38 mm). Drill
1
2
Phillips to
6-lobe screw
6-lobe adapter
Align top
edges
Drill through
these holes.
1
1
/
"
2
screw
/
" nut
1
4
/
" (long)
1
2
3
Publicidad
Tabla de contenido
