IKEA SPOLAD Instrucciones De Instalación página 5

4.
Attach plastic studs
Plastic studs attached
with 4 short screws
Visible side
Using a / " nut driver, attach the 4 plastic studs to the door
5
16
front using the four / " hex-head (short) screws provided.
5
16
5.
Attach custom panel
Align the studs on the door front to the keyhole slots on the
door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide the door front down until the top
surface of the door front is flush with the top of the door.
Wooden panel
assembly
6.
Remove the short screws
Remove 4 short screws
and replace with long
screws provided.
Remove the short screws (2nd and 3rd from top) on either side
of the inner door panel. Use tape to mark a
the hole depth of approximately 1
using the door liner hole as a guide into the door front. Install the
4 remaining long screws.
Align top
edges
Voxtorp kitchen
door panel
/ " drill bit to gauge
3
32
/ " (38 mm). Drill 4 pilot holes
1
2
5