Kit Preparation - Metra Electronics 95-8202 Manual De Usario

For the Scion tC (both generations) and xA:
Cut off the front upper section of the ISO DDIN trim plate
brackets, as shown by the dotted lines labeled "A" in.
(Figure A)
Continue to Kit Assembly
A
A
A
B
B
(Figure A)
18
For the Toyota Rav-4 2001-2005, Toyota Highlander 2001-
2007 (without factory navigation), Toyota Tundra 2003-2006
and Toyota Sequoia 2003-2007:
Cut off the rear section of the ISO DDIN trim plate brackets,
as shown by the dotted lines labeled "B" in. (Figure A)
Continue to Kit Assembly
A
If bracket is broken
B
B
during trimming use
this portion.
(Figure B)

KIT PREPARATION

For the Scion FR-S 2013-2016 and Subaru BRZ 2013-2015:
Cut the ISO DDIN trim plate brackets as shown in. (Figure B)
Note: Care must be taken to cut this. A Dremel tool and a
steady hand must be used. If the bracket is damaged you can
still use the it by using the single screw hole leftover. If you do
go this route, you will have to brace up the rear of the radio to
prevent it from dropping down. (Figure B)
Continue to Kit Assembly
For all other vehicles skip to Kit Assembly.
Carefully cut-out the shaded area
using a dremel tool to accommodate
for the factory bracket.
Style of factory
brackets may differ.
1.800.221.0932
|
MetraOnline.com