Honeywell HW7000EH Manual Del Propietário página 15

Step 3: Install Handle Assembly
To install handle assembly, you will need:
‰ Handle brackets (2)
‰ Handle bars (2)
‰ Pins (2)
‰ Chains (2)
‰ Rubber handle grips (2)
‰ M6 x 40 mm long flange-head hex bolts (6)
‰ M6 serrated flange nuts (6)
‰ Socket wrench with 10 mm socket
‰ 10 mm open end wrench*
* Not included
1. Hold handle bracket over pre-drilled holes on frame
as shown in Figure 10.
FIGURE 10: Handle Bracket to Frame
Attach bracket to frame using 40 mm long flange-
2.
head hex bolts and serrated flange nuts and tighten.
3. Slide handle bar through center of each bracket and
line up bolt holes.
FIGURE 11: Insert Handle Bar to Bracket
Attach handle to each bracket using 40 mm long
4.
flange-head hex bolt and serrated flange nut to hole
closest to frame and tighten.
NOTE:
Handle should be in a horizontal position after tightening
bolts and nuts. If handle seems to hang down, tighten
bolts and nuts further.
HW7000EH Portable Electrical Generator Owner's Manual
5.
6.
*
7.
Once properly installed, the handles can be collapsed, if
desired, by removing the pins.
• Keep hands and fingers clear from hinges when
• Handles should only be used to roll the generator to a
•
•
Attach pin to chain.
FIGURE 12: Attach Pin and Chain
Attach chain to handle bracket as illustrated below.
Insert pin through bracket and handle.
FIGURE 13: Attach Chain to Handle Bracket
Slide rubber handle grip onto each handle bar and
push to achieve snug fit.
FIGURE 14: Attach Grips to Handle
CAUTION
Hands and fingers can be pinched from collapsible
handles.
collapsing generator handles.
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
To collapse handles, remove pins and push firmly
down on handle until it rests vertically against genera-
tor frame.
To return handles to horizontal position, pull up on
handle and lock with pins.
www.honeywellgenerators.com
Assembly
9