Working Cycle Example; Filling The Tank; Operation; A - Checks Before Use - Ghibli & Wirbel ROUND 45 SM 55 TOUCH Uso Y Mantenimiento

6.2 WORKING CYCLE
EXAMPLE
Setting a washing cycle with brushes and
drying.
- Turn the key selector (43) to "ON".
- Press the button (46) to enable brush ro-
tation.
- Press the button (48) and the vacuum will
start.
NOTE:
It is possible to alter the speed, even during
the work cycle, with the machine in motion,
by acting on the potentiometer.
- Brush the touch button (20); the machine
will start its work cycle.

7.1 FILLING THE TANK

(Fig. 10
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Remove the hose (26) supplied, connect
one end (26a) to a tap and insert the oth-
er end (26b) in the tank (5).
- Check that the tap (31) is open.
- Turn on the tap and fill the tank (5) to the
MAXIMUM LEVEL (NOT EXCEED) indi-
cated by the label placed on the transpar-
ent tube (15).
- Pour the detergent fluid in the tank.
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
(Fig. 9)
)
EN - 8
Professional Cleaning Machines Since 1968
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
8.1 OPERATION (Fig. 1-9)

8.1.a - Checks before use

- Check that the exhaust tube (12) of the
recovery tank is properly coupled and
properly sealed.
- Check that the connector (49) on the
squeegee (11) is not blocked and that the
hose is connected correctly.
- Check that the clean water exhaust tube
(15) is correctly coupled to the supports
and that the tap (31) is open.
- Turn the key selector (43) to "ON" and
check the battery charge.
8.1.b - Preparing the machine and
choosing the cycle (Fig. 9-11)
- Turn the key selector (43) to "ON" and
check the battery charge, indicated by
the lighted low battery indicator (47).
- Release the lever (3 Fig. 11) and lower
it; the floor squeegee (11 Fig. 11) is low-
ered.
- Press the pedal (19 Fig. 11), disengage it
from its lodging and lift it: the brush (10
Fig. 1) will be lowered.
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- To perform only the drying cycle, press
the button (48 Fig. 9), the aspirator will
start.
Use the appropriate controls to activate
the drive mechanism, if available for the
model in use.
www.ghibliwirbel.com