Truper SME-10X-3 Manual Del Usuario página 23

Assembly
5
Guide
Lane
Miter
Guide
Guide
Gutter
Cutting Disc
• Assure the guide is parallel to the disc. Align it with the table slot. If the guide
drags when trying to travel, adjust it back foot to align it to the table surface.
• The guide back side may stay 0.06" open from the parallel to prevent the
pieces are stuck between the disc and the guide when cutting.
Rear rail
Front Rail
Before tightening the bolts in both rails,
double check there is no obstruction in
the table to allow the miter guide to run
freely.
Extension
Table
Guide
Lock Guide
6
Set the guide in the
lane and lower the
guide lock lever
before mounting
into the lanes.
7
ENGLISH