Troubleshooting - Truper SME-10X-3 Manual Del Usuario

Problem Cause
The saw will not start. • Cable disconnected from the power supply.
• Fuse blown or circuit breaker jumped.
• Damaged cable.
The overload jumps • The extension cable or the wiring have wrong
frequently. gauges.
• The feed is too fast.
• The disc need cleaning or replacing.
• The disc is stuck with the work piece against the
guide.
• The disc is stuck with warped wood.
• Low local power supply.
The angles in the • The stoppers in the angle control mechanism
cuts are not precise. are not adjusted.
• The pointer in the tilting angle is not adjusted
properly.
The material gets • The guide is not aligned properly.
stuck in the disc. • The disc is stuck with warped wood.
The material is stuck • The rivet knife is not aligned properly.
in the rivet knife.
The cuts are not • Dull or damaged disc.
satisfactory. • Disc is mounted backwards.
• The disc has tar or resin.
• The disc is not the right one for the job.
• The table has tar or resin hindering the feed.
The disc is not • The extension cable or the wiring have wrong
reaching its full gauges.
speed. • Low local power supply.
• The motor is not cabled with the right voltage.
• The table is not mounted properly into the
The equipment cabinet.
vibrates in excess. • The equipment is set on unleveled ground.
• The disc is damaged.
• The V- bands are damaged.
• The V - bands do not have the right tension.
• The pulley is bent.
• The motor is not mounted correctly.
• Screws and bolts are loose.
The disc cannot be • The control mechanisms are dirty.
raised or tilted freely.
14
ENGLISH

Troubleshooting

Solution
• Connect the cable to the power supply.
• Replace the fuse or activate the circuit breaker.
• Replace the cable.
• Replace the extension cable or the wiring.
• Reduce the feeding speed.
• Clean or replace the disc.
• Check and adjust the guide alignment. (see page 11).
• Work with a new piece of wood that is not warped.
• Call your utility company.
• Adjust the stoppers in the angle control mechanism
(see page 11).
• Adjust the cutting disc to 90° off the table using a
set square and set the pointer in zero.
• Check and adjust the guide alignment (see page 11).
• Work with a new piece of wood that is not warped.
• Check and adjust the rivet knife alignment (see
page 9).
• Replace the disc.
• Change the disc position.
• Remove the disc and clean it with turpentine and steel
fiber.
• Replace the disc.
• Clean the table using turpentine and steel fiber.
• Replace the extension cable or the wiring with the
right gauge.
• Call your utility company.
• Go to a certified electrician and connect correctly.
(see page 10).
• Tighten the table screws.
• Set the equipment on flat and leveled ground.
• Replace the disc.
• Replace the bands.
• Adjust tension of the bands.
• Replace the pulley.
• Check and adjust the motor mounting.
• Tighten all the screws in the equipment.
• Brush or blow away the residues accumulated in
the control mechanisms and lubricate with lithium
white grease.