Adjustments - Truper SME-10X-3 Manual Del Usuario

Adjustments

Cutting Disc Height and Angle
• Loosen the blocking knob (A) and turn the control
flywheel (B) until the disc reaches the desired height.
• The disc teeth shall be 1/8" to 1/4" height above the
work piece surface.
• Tighten the blocking knob to keep the disc in the
selected height level.
• Loosen the blocking knob (C) and turn the control
flywheel (D) until the disc is in the angle you need.
• The disc can be adjusted from 90° to 45°
• Tighten the blocking knob to keep the disc in the chosen
angle.
• Before using the saw for the first time, make sure the 90°
and 45° are correct. Use a combination square set.
• If the event the degrees are not correct, adjust the
stoppers in the disc angle control mechanism inside the
cabinet.
• The adjustment shall be carried out loosening, outward
or inward, the blocking nut and then, the adjusting nut,
whatever is needed.
• Check the disk angle periodically to make the
adjustments if necessary.
Stopper
Adjusting
Nut
Blocking
Nut
Guide
• In the event that the guide is mounted and the blocking
lever (E) is down but not aligned with the table slots, lift
the blocking lever, disassemble the guide, set it with the
down side up and adjust the screws in the back (F).
• Pressure in the blocking lever can be adjusted turning
both knobs in a synchronized manner (G). Before turning,
loosen the blocking nuts.
• To adjust the guide perpendicular to the table, place a set
square (H) onto the table and against the guide side. Turn
the knobs (I) until the guide sits perpendicular to the
table. Before turning, loosen the blocking nuts.
• The pointer (J) can be adjusted when necessary to that
the red line will match the zero in the scale. Loosen the
two screws fixing it to the guide.
C
D
45°
Table Surface
I
F
G
E
A
B
90°
Table Surface
H
I
J
F
G
11
ENGLISH