Machine Care - Bissell Big Green Complete 7700 Serie Guia Del Usuario

M
aintenance and care

Machine care

for best results, a few simple steps can assure
your machine is well maintained after your
cleaning is complete.
1. Press all buttons off. unplug the machine
and wrap the cord.
2. after emptying the dirty water from the
collection tank, rinse it out thoroughly with
hot water. Remove all inner parts (water fil-
tration tower and mode selector) if desired.
Rinse them and allow to dry completely
before returning into tank.
NOTE: To remove inner parts, turn
mode selector to remove. Pull
mode selector straight out towards
you. The water filtration tower can
now be taken out through the top
of the tank.
3. for wet cleaning, remove and clean
all tools that were used. allow to dry
completely before storing.
4. Remove the hose, taking care to keep
both ends up to avoid spilling. dump
out any remaining water and flush
clean with hot tap water. allow to dry
completely before storing.
5. a. Pre-motor filter: take apart the top lid by
pulling the tab away from the separator.
inspect the foam filter. if dirty, rinse clean
and allow to dry completely before return-
ing it to the machine. Re-assemble the top
lid by placing the filter in its spot and re-
attaching the separator. use care to make
sure the "t" pieces are lined up under the
shallow grooves on the top lid itself.
b. filter: this filter is located at the back
of the machine, underneath the Quick
Release cord Wrap. use one finger to
depress the latch and pull the door down.
open towards you and down to the
ground. use two hands to remove the filter
from its slot. if dirty, rinse clean and allow
to dry completely before returning it to the
machine. make sure the filter door is fully
closed prior to operating the machine.
w w w . b i s s e l l . c o m
WARNING:
to reduce the risk of fire,
electric shock or injury, unplug
from the outlet before servicing.
Water mode selector
filtration tower
8 0 0 . 2 3 7 . 7 6 9 1
15