Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE CALLING
FOR SERVICE (continued)
Your washing machine is equipped
with an automatic
error-monitoring
system to detect and diagnose problems at an
early stage.
Water in the washer
drains slowly
or nat
at all, or the dlsplay
SHOWS:
I
F_F
uc|
Washer fills with
water slowly
or nat
at all, or the dlsplay
SHOWS,"
Cycle won't start, or
the dlsplay shows:
|
,-
ac/I
|
,-n|
OL-'L-" |
The display shows:
I
I H-
u,:|
The display shows:
I
J F
c0_-|
The dlsplay shows:
I
FF
The display shows:
I
f'_F
,-,-|
The display shows:
J F
I L,:m
The display shows:
| PFll
Drain hose is kinked, pinched, or clogged.
The drain pump filter is clogged.
Drain discharge is more than 96 inches above
bottom of washer.
Water
supply faucets are not open fully.
Water
line hoses are kinked, pinched, or
crushed.
Water
inlet filters are clogged.
Water
supply pressure to faucet or house
is too low.
Water
supply connected
with leak-limit-
ing hoses.
The door is not closed
properly.
Load is too small.
Load is out of balance.
Control error.
Water
level
is too high due to a faulty
water
valve.
The water level sensor is not working
correctly.
A motor
error
has occurred.
A power failure
has occurred.
Make sure the drain hose is free of clogs, kinks, etc.,
and is not pinched behind or under the washer.
Clean the drain pump filter. See Maintenance in the
Care and Cleaning section.
Adjust or repair drain. Maximum drain height is 96
inches.
Make sure that the water faucets are fully open.
Make sure the hoses are not kinked or pinched.
Be careful when moving the washer during
cleaning
and maintenance
Clean the inlet filters.
See Maintenance
in the Care and Cleaning
sec-
tion.
Check another faucet in the house to make sure
that household water pressure is adequate
and
flow is not restricted.
Hoses designed to limit leaks can trip falsely and
prevent the washer from filling. The use of leak
limiting
hoses is not recommended.
Make sure that the door is closed properly
and
press the START/PAUSE button. After starting
a cycle, it may take a few moments before the
drum begins to turn or spin. The washer will not
operate
unless the door is locked.
If the door is closed and locked and the open
door error message is displayed,
call for service.
Add 1 or 2 similar items to help balance the load.
The washer has an imbalance detection and
correction system. If individual heavy articles
are loaded (bath mah bath robe, etc.) and the
imbalance is too great, the washer will make several
attempts to restart the spin cycle. If an imbalance
is still detected, the washer will stop and the error
code will display.
Unplug the washer and wait 60 seconds. Reconnect
power and try again. If the error reappears, call for
service.
Close the water faucets,
unplug the washeb and call
for service.
Close the water faucets,
unplug the washeb and call
for service.
Allow the washer to stand for 30 minutes and then
restart
the cycle.
If the LE error
code
persists,
call
for
service.
If the power to the washer has been interrupted
during a cycle, the PF error code will display
the next time the washer is turned ON. This will
alert you to the fact that the previous cycle may
not have been completed.
Select any cycle to
clear the error code and use the washer.
3O
Publicidad
Tabla de contenido
