Kenmore 796.4118#31 Serie Manual De Uso Y Cuidado página 10

CONNECTING THE DRAIN HOSE
° The drain hose should always be properly secured. Failure to
properly secure the drain hose can result in flooding and property
damage.
° Do not install the end of the drain hose higher than 96 in. (243.8
cm) above the bottom of the washer.
° The drain must be installed in accordance with any applicable
local codes and regulations.
° Make sure that the drain hose is not stretched, pinched, crushed,
or kinked.
NOTE:
A drain hose extension kit is
available if the drain hose is not
ioncj enough. Do not extend the
drain hose more than 6 feeh as
this wiii cause poor draining,
which wiii result in poor wash
and spin performance.
Option 1 : Standpipe
f
Elbow
Bracket
\
Drain Hose
Stra
\ J
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches past
the end of the elbow bracket. Use a tie strap to secure
the drain hose in place.
NOTE:
* Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom of the washer.
* The drain hose should be inserted no more than 8-12
inches into the standpipe. Inserting more than 8-12
inches can cause mold or microorganisms to spread to
the inside of the washer.
Option 2: Laundry Drum
/
_ ,e_t_ S'n k
_e_Strapl -_
Drain Hose
J
The elbow bracket should be installed near the end of
the drain hose° Hang the end of the drain hose over the
side of the utility sink. Use a tie strap to secure the drain
hose in place°
Option 3: Floor Drain
f
Drain Hose
\
Floor Drain
J
Insert the end of the drain hose into the floor drain°
If possible, secure the hose to prevent it from moving or
coming out of the drain.
CONNECT TO THE POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet.
Plug in the washer.
J
10