Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
AND REMOVING
SHiPPiNG
BOLTS
When removing the washer from the carton base, be sure
to remove the foam drum support in the middle of the
carton base. See drawing
below.
if you must lay the washer down to remove the base
packaging
materials, always protect the side of the
washer and lay it carefully
on its side. DO NOT lay the
washer on its front or back.
To prevent internat damage
during transport, the washer
is equipped
with four shipping bolts and plastic retainers.
iMPORTANT:
* These shipping bolts and retainers MUST NOT be re-
moved until just before moving the washer into its final
position.
* These bolts and retainers MUST be removed before
operating
the washer.
Failure to remove shipping bolts and retainers may
cause severe vibration
and noise, which can lead to
permanent
damage to the washer.
NOTE: The power cord is secured to the back of the
washer with a shipping bolt to help prevent operation
with shipping bolts in place.
Shipping
Bolts
" Power
Cord
J
1. Save the foam block for future use. If the washer
must be moved in the future, this will help prevent
damage
to the washer during transportation.
Shipping
Bolts
2. Remove the bolt assemblies by wiggling
them
slightly while pulling.
3. Locate the four hote caps included in the accessory
pack and install them in the shipping
bolt holes.
NOTE: Save the bolt assemblies for future use. To
prevent damage
to internal
components,
DO NOT
transport
the washer without
reinstalling
the shipping
bolts.
Publicidad
Tabla de contenido
