Special Functions - Kenmore 796.4118#31 Serie Manual De Uso Y Cuidado

Lavadora automatica de carga frontal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIAL FUNCTIONS
CONTR. OL LOCK
ControlL0ckl_l Use this option to disable
the controls.
J The washer can only be locked during a
cycle. This feature
can prevent children
from changing
cycles or operating
the machine. Once
set, the controls remain locked and must be turned OFF
before
the controls can be used again. Once the washer
has shut off, the power
button wilt allow the machine
to be turned ON, but the controls will still be locked.
When the controls are locked, the Control Lock LED wilt
illuminate and "CL" will display
alternately
with the
estimated
time remaining.
To activate the control lock, press and hold the EXTRA RINSE
button for five seconds.
CLEAN WASHER.
I Detergent residue can build up in the wash
CleanWasher_drum over time and can lead to a mildewy
or musty smell. The Clean Washer cycle is
specially designed to remove this buildup using bleach or
another cleaner designed specifically for cleaning front load
washers. Run the Clean Washer cycle once a month, or more
often under heavy use conditions or if odor is present. See
complete instructions in the CARE AND CLEANING section.
@
O
Turn ON the washer and press the CLEAN WASHER
button. Selecting
any other cycle after Clean
Washer
has been selected will cancel the Clean
Washer cycle.
Fill the bleach dispenser to the MAX line with liquid
chlorine
bleach. Do not overfill the bleach dispenser.
Overfilling
will cause the bleach to dispense
immediately.
NOTE: For other drum cleaning
products, follow
the cleaner
manufacturer's
instructions
and
recommendations.
For powdered
cleaning
products,
add the cleaner to the main wash compartment of
the dispenser drawer. Place tablet
cleaners directly
into the drum.
Press the START/PAUSE
button
to start
the cycle.
After
the cycle
has ended,
secure
the door
slightly
ajar
with
the door
magnet.
This will
promote
air
circulation
and allow
the interior
of the machine
to
dry.
To use this feature,
close the door just until it
contacts
the door
magnet.
NOTE:
Do NOT
use this cycle
with
clothes,
and do
NOT
add
detergent
or fabric
softener.
AUTO SOAK
F
] Use the Auto Soak option to presoak
Auto Soak
garments
to help remove difficult
spots
or stains on fabric.
This option
provides
a 30 minute presoak prior to the start of the selected
cycle. At the end of the presoak time, the selected cycle
will use the same water.
To use the AUTO SOAK feature,
press and hold the
STEAM TREAT button for five seconds.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido