Unpacking Instructions - Fanimation Punkah Manual Del Propietário

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
•
One Phillips head screwdriver
•
One stepladder
•
One ¼ blade screwdriver ˝
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 7). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step
is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding
your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 18, page 13)
•
˝ Socket head wrench
•
⅛ Hex "L" wrench ˝
•
One wire stripper

Unpacking Instructions

Punkah
FP780 ®
Motor Assembly Package
Hardware Bag
for Motor Mounting
Motor Cover
Motor Mounting
Wiring outlet box and box connectors must be of type re-
quired by local code. The minimum wire would be a 3-con-
ductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
FP780 Motor Assembly Package
• Punkah Motor Assembly
™
• Motor Mounting Bracket
• Motor Cover
Motor Mounting Hardware Bag
contains:
– Lag Bolt, 2˝ long (2)
– Lag Bolt, 4˝ long (2)
– Hex Head Philips Screw (4)
– Lockwasher (4)
– Motor Cover Screw (3)
– Wire Nut (3)
Rod Mounting Hardware Bag
contains:
– Motor Link
– Hex Head Philips Screw
– Spacer
– Nylon Lock Nut
– Nylon Washer (2)
– Socket Head Screw, 1¾ ˝ long
– Socket Head Scre
– 5 mm Allen Wrench
– 6 mm Allen Wrench
Hardware Bag
for Rod Mounting
Inner Rod
Assembly (2)
Bracket
3
Materials
Wire Size A.W.G.
FP720 Fan Head Assembly Package
• Punkah Fan Head Assembly
™
– Base Mount
– Pivot Assembly
– Blade Cover
• Inner Rod Assembly (2)
• Outer Rod Assembly
Fan Head Hardware Bag contains:
– Lag Bolt, 2˝ long (2)
– Flat Washer (2)
– Socket Head Screw, 1½˝ long
– Socket Head Screw, 2˝ long
– Nylon Lock Nut
– Nylon Washer (2)
– Blade Cover Scre
– 3 mm Allen Wrench
w, 2¼ ˝ long
FP720 Punkah
®
Fan Head Assembly Package
Pivot Assembly
Blade Cover
Outer Rod
Assembly
14
12
w, / ˝-24 x / ˝(2)
3 3
16 8
Base Mount
Hardware Bag
for Fan Head
Assembly