System Lay-Out; Technical Data - RIB IDRO 27 Manual De Instrucciones

SYSTEM LAY-OUT

1 - IDRO operator
2 - Tuned aerial
3 - Flashing lamp
4 - Key selector
5 - Photoelectric cells (external)
6 - Photoelectric cells (internal)
P
RE-INSTALLATION CHECKS
The leaf must be fixed firmily on the hinges to the pillars,
must not be flexible during the movement and must move
without frictions.
Before the installation of IDRO, verify all dimensions etc.
There's no need for any modification, if the gate is like that
shown in Fig. 1.
Gate features must be uniformed with the standards and
laws in force. The door/gate can be automated only if it is in
a good condition and its conditions comply with the EN
12604 norm.
- The door/gate leaf does not have to have a pedestrian
opening. In the opposite case it is necessary to take the
appropriate steps, in accordance with EN 12453 norm (for
instance; by preventing the operation of the motor when
the pedestrian opening is opened, by installing a safety
microswitch connected with the control panel).
No mechanical stop shall be on top of the gate, since
mechanical stops are not safe enough.
ƒ
†
‚
‡
‡
TECHNICAL
DATA
Max. leaf length
Max. leaf weight
Max. travel
Average opening time
Thrust force
EEC Power supply
Motor capacity
Power absorbed
Capacitor
EEC Power supply
Motor capacity
Power absorbed
Capacitor
Normative cycles
Daily operations suggested
Service
Guaranteed consecutive cycles
Lubrification
Weight of electroreducer
Noise
Volume
Operating Temperature
Protection
N.B.: In the case of leaf longer than 1,8 metres, an electric lock must be fitted to ensure efficient closing.
„
…
‚ † … ‡
‡
27R 27/1B 27S/R 27S/1B 39/R
m. 2,5 1,6
kg 250
cm 27
s. 11
N 2500
W 160
A 0,9
µF
W
A
µF
N° 300 - 11s/2s
N° 300
80%
N° 300
kg 8,2
db
m 0,0086
3
°C
IP
1
39/1B
2,5 1,8 7 1,8
300 300 400 400
27 39
16÷18 27÷47
4700 4700
230V~ 50Hz
220 220
1,1 1,1
12
120V~ 60Hz
220
2
60
500 - 18s/2s 800 - 30s/2s
500 800
90% 100%
500 800
OX Super
8,2 10,5
<70
0,0086 0,0084
-20 ÷ +55°C
55
G G
B B