ResMed Swift FX Nano Manual Del Usuario página 13

Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks
must be reprocessed according to cleaning and disinfection
instructions available on ResMed.com/downloads/masks.
Troubleshooting
Problem/possible cause
Mask is too noisy.
Vent is blocked or partially
blocked.
Elbow inserted incorrectly.
Mask is leaking.
6
Solution
If the vent requires cleaning, use a soft
bristle brush.
Remove the elbow from the mask and
then reassemble according to the
instructions.
Ensure that the swivel ring on the elbow
has not been inserted too far into the
cushion.
Refit or reposition your mask.
Readjust the back strap to bring the mask
closer to the face and improve your seal.
Check that your mask is assembled
correctly.