Ega Master EGATronik 65424 Manual De Instrucciones página 15

1. Pres to switch to auto horizontal measurement
2. According to the fiashing edge, point the laser to the first point of the target and press
3. The angle degree between the hypotenuse and the horizontal edge, the length of the
hypotenuse/vertical edge/horizontal edge will be displayed on the screen from top to bottom.
1. Pres to switch to auto vertical measuremen
2. According to the flashing edge, point the laser to the first point of the target, press
measure the first hypotenuse.
3. Rotate to the second point of the target with the set reference as center, press
measure the second hypotenuse.
4. The angle degree between both hypotenuses, the length of both hypotenuses, the vertical
distance will be displayed on the screen in sequence.
AUTO HORIZONTAL MEASUREMENT
AUTO VERTICAL MEASUREMENT
.
.
to
to
15