Single Measurement; Area Measurement - Ega Master EGATronik 65424 Manual De Instrucciones

Turn on the meter and it will enter single measurement mode by default. Point the laser at
the measurement target, then press
bottom of the screen.
Continuous Measurement (Max/Min Measurement)
This function can be used to measure the diagonal of a house, to look for levels, to stake
out, etc.
Long press
Point the laser at the measurement target, then press
MAX/current measured value will be displayed on the screen.
This function will stop automatically after 5 minutes of continuous measurement.
MIN
1. Press to switch to area measurement
2. According to the flashing edge, point the laser at the first point of the target, press
measure the first edge (length).
3. Point at the second point, press
4. The calculation results of the length, width, circumference and area will be displayed on the
screen.
12

SINGLE MEASUREMENT

to enter the continuous measurement.

AREA MEASUREMENT

and the measurement result will be displayed al the
MAX
.
to measure the second edge (width).
to stop measuring. The MIN/
to