Volume Measurement; Direct Pythagoras Measurement - Ega Master EGATronik 65424 Manual De Instrucciones

1. Press to switch to volume measurement
2. According to the flashing edge, point the laser at the first point of the target, press
measure the first edge (length).
3. Point at the second point of the target, press
4. Point at the third point of the target, press
5. The volume calculation results will be displayed at the bottom of the screen.
AII Pythagorean measurements can be applied to different plane measurements, jusi ensure
that the right-angle side is perpendicular to the object being measured.
Note: In Pythagorean Theorem, the right-angle side cannot be longer than the hypotenuse;
otherwise a calculation error will occur.
1. Pres to switch to direct Pythagoras measurement
2. According to the flashing edge, point the laser at the first point of the target, press
measure the hypotenuse.
3. Rotate to the direction perpendicular to the target with the set reference as center, press
to measure one right-angle side.
4. The calculation result of the other right-angle side is displayed at the bottom of the screen.

VOLUME MEASUREMENT

PYTHAGOREAN MEASUREMENT

DIRECT PYTHAGORAS MEASUREMENT

.
to measure the second edge (width).
to measure the third edge (height).
.
to
to
13