Ega Master EGATronik 65424 Manual De Instrucciones página 17

*RANGE
The range data is based on the rear reference; the maximum range may vary depending on
the model version, please refer to the product packing for the actual ranges.
**ACCURACY
("D" represents the measured length)
Under good measurement conditions (good measurement surface/room temperature/indoor
lighting, etc.): up to the rated range.
Under bad measurement conditions (too much light, weak reflection on the surface of the
measured objects or large temperature difference, etc.): the error may increase.
Tip: Use a target board or a good reflective surface in case of poor daylight or target
reflection.
In the ideal state, the short distance accuracy can be up to 1mm.
(Ideal state refers to constant speed (speed < 1m/s) and flat contact surface; short distance
means <1.5m)
Angle Error
0.1º is the error caused by the temperature, D is +/ -0~45º.
For example, the 0 degree error is +/ -0.3º at room temperature, the 45 degrees error is +/
-0.85ºat non-room temperature.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed
number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
NOTES
GUARANTEE
17