Technical Parameters - Ega Master EGATronik 65424 Manual De Instrucciones

AII information is displayed in code or "Error". The following shows the codes and their
explanations and the corresponding solutions.
Code
204 Calculation error
220
The refiected light received
255 is weak, or the measurement
time is too long
The received signal is too
256
261
500 Hardware malfunction
*Range (m)
**Accuracy (mm)
Single measurement
Continuous measurement
Area measurement
Volume measurement
Direct Pythagoras
lndirect Pythagoras (1)
lndirect Pythagoras (2)
Add/Subtract
Display type
Measurement reference
Measurement units
Data logging
Auto power off
Auto laser off
Laser class
Laser type
Battery type
Operating temperature
Storage temperature
16
FAULT CODE - PROBLEMS AND SOLUTIONS
Problems
Low battery
strong
Over range

TECHNICAL PARAMETERS

Size (mm)
Follow the instructions and operate again
Please replace the battery or charge it
Please improve the reflective surface (use a
reflector, white paper, etc.)
Please improve the reflective surface (use a
reflector, or do not aim at strong light)
Please measure within the range
lf it still appears after the meter has been turned on/
off multiple times, please contact your dealer.
± (2.0mm+5x10
Front/rear reference
3 minutes without operation
30 seconds without operation
630-670nm, <1mW
OºC ~ +40ºC (32ºF
-20ºC ~ 70ºC (-4ºF ~ 158ºF)
Solutions
60m
D)
-5
ѵ
ѵ
ѵ
ѵ
ѵ
ѵ
ѵ
ѵ
2.0" EBTN screen
m/ft/in/ft+in
20 groups
2
AAAx2
~ +104ºF)
122x52x29.5