EINHELL FB 120 K Instrucciones De Montaje página 7

Anleitung FB 120Einhell
To assemble the cold frame you need a light
hammer and a meter rule. Before commencing with
the assembly, please read the instructions carefully
and study the illustrations. When fitting the profiles
on the panels, always check the length of the profiles
first and do not assemble the panel until you have
the correct profile. We recommend applying a little
edible oil or fat to the edge of the panel or profile.
You will then find it easy to tap the profiles into
position with the palm of your hand or a hammer.
Make sure that there is no sharp cut edge on the
panel. If there is, scrape it off with a knife. If there is,
scrape it off carefully with a knife.
Assembly will be easy if you proceed in the
following order:
1. Check the contents against the list of parts.
2. Begin with the lid (D), size 980 x 580 mm.
3. First press the long profiles (1) and then the
short profiles (2) onto the plastic web panel. The
long profiles (1) should project an equal distance
(1 cm) beyond the ends of the plastic web panel.
See Figure 3.
Make sure that all the sections point downward
(see Figure 1).
4. The procedure for the rear (R) and front (V)
elements is the same as for the lid. Once again,
make sure that all the profiles point in one
direction (Figure 1 and Figure 3).
5. Assemble the side elements in the same way,
but this time arrange the profiles (8) so that they
point outward (Figure 1).
6. Now join the 4 side elements (R - S + V) together
using the profiles (5). Simply plug the profiles (5)
together from above or below (see the detail in
Figure 2).
7. Plug the ridge profile (9) and the two side profiles
(10) together using corner angles (11).
8. Arrange the pre-assembled front and side
elements so that you can slide the ridge by its
side profiles down into the profiles (3) of the pre-
assembled sides.
9. Place one corner angle (11) under each of the
four corners as shown in Fig. 1 and press the
base profiles into the corner angles until they
latch home.
24.10.2001 10:07 Uhr
10. Fit a corner angle in center position on the left
11. Slide the lid (D) by its profile (1) into the ridge
12. Slide the two stay-bars (13) into the front profile
13. Once you have chosen the right position for your
Please assemble the profiles in the correct order.
The illustrations show you exactly how the
various profiles have to be joined together.
(Figure 3) To identify the profiles, compare them
with the item numbers in the list of replacement
parts and check their length.
Seite 7
and right, making sure their tips point inward
(Figure 1). Be sure to work on level and firm
ground when fitting the corner angles.
profile (9) from the side. When the lid is exactly
central on the frame, fix it in place with one
stopper (14) to the left and one to the right of the
lid. The stoppers (14) are simply plugged into the
profile (1).
(1) of the lid. The lid can then be propped open
in two positions.
cold frame, fix it in place with the earth pegs (12).
Insert one peg through the hole in each corner
angle (11) and press firmly into the ground.
GB
7