Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Check that the two red buttons have snapped out, otherwise the door cannot be closed.
The two red buttons have
snapped out
CORRECTLY
NOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-
ped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it force-
fully from the top and bottom simultaneously, as shown in figure 28.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the outlet then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser.
• replace the drip tray, complete with the grounds container;
• close the service door.
12 CHANGING AND SETTING THE MENU PARAMETERS
The following menu parameters and functions can be changed by the user:
• Clock
• Auto-start time
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
• Water hardness
• Factory default values
12.1 Setting the clock
To set the clock, proceed as follows:
• Press the
button (the light over the button comes on) then press the
the appliance displays
• Press the
rapidly).
• Press the
button to confirm the value;
• Press the
button to exit programming mode or
12.2 Setting auto-start time
This programs the time the appliance will come on automatically.
• Make sure the clock on the appliance is set as described above.
• Press the
16
CORRECT
button to set the clock. (If you hold the
button then press the
INCORRECT
CLOCK 00:00
button repeatedly until the appliance displays:
START TIME 00:00
The two red buttons have not
snapped out
button repeatedly until
button down, the time is changed
to change other parameters.
Publicidad
Capítulos
Tabla de contenido
