Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16.3 Cleaning the milk container
Proceed as follows:
•
Remove the milk spout (1) and intake tube (2).
•
Remove the froth regulator (3) by pulling it
outwards (see figure)
•
Wash all the components thoroughly with hot
soapy water. Make sure there is no milk residue
inside the two holes in the lid of the milk con-
tainer,indicated by the arrows in the figure,or in
the groove (4) of the froth regulator.
•
Replace the froth regulator, intake tube and
milk spout back in the milk container lid.
17 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the
button, when the appliance is ready, you can use the internal menu to modify the fol-
lowing parameters and functions:
•
Clock
•
Auto-start time
•
Auto start ON/OFF
•
Descaling process
•
Coffee temperature
•
Length of time the appliance remains on
•
Water hardness
•
Resetting factory default values
•
Washing procedure
•
BEEP ON/OFF
Note: the last line of the display is the guide to the function buttons.
17.1 Setting the clock
To set the clock, proceed as follows:
•
Press the P button, then press the
repeatedly until the menu arrow is on:
•
Press the
button (corresponding to the SET symbol flashing on the display) to set the time on the clock.
(If you hold the button down, the time is changed rapidly.)
•
Press the OK button to confirm the value.
•
Press the P button (corresponding to the ESC symbol flashing on the display) to exit programming mode
or
to change other parameters.
Note: to display the time with the appliance off, press any button. The time will be displayed for five minutes.
17.2 Setting auto-start time
This function programs the time the appliance will come on automatically and be ready for use.
•
Make sure the clock on the appliance is set as described above.
•
Press the P button then press the
repeatedly until the menu arrow is on:
•
Press the
button (corresponding to the SET symbol flashing on the display) to set the auto-start time.
(If you hold the button down, the time is changed rapidly.)
•
Press the OK button to confirm the value.
•
Press the SET button again and the appliance displays:
Press the
button (corresponding to the SET symbol flashing on the display) to modify the function
(the appliance displays: AUTO-START YES)
C o l l e c t i o n
button (corresponding to the
CLOCK 00:00
button (corresponding to the
START TIME 00:00
AUTO-START NO
4
1
2
symbol flashing on the display)
symbol flashing on the display)
3
17
Publicidad
Capítulos
Tabla de contenido
