Master Forge RT2417S Manual Del Usuario página 21

COOkINg WITH gAS
For Natural gas Connection
Preparing:
1. Turn off gas supply and then remove cap on gas supply side.
2. Recommended: Install a shut-off valve on gas supply side before installing the socket.
3. Socket should be installed by an authorized technician in accordance with the national fuel gas
code (NFPA 54/ANSI223.1).
4. Before inserting plug, turn on gas supply and leak test all connections including the stem of the
shut-off valve and the opening of the socket. For best results, use an ammonia-free soap and
water solution.
Operating Instructions:
1. To connect, push back socket sleeve (Fig. 23).
Sleeve
Socket
2. Insert plug and release sleeve (Fig. 24).
3. Push plug until sleeve snaps forward (Fig. 25).
(Gas will flow automatically. Failure to connect
plug properly to socket will inhibit gas flow to
the appliance.)
4. Test connection with ammonia-free soap and water solution.
To disconnect:
1. Pull sleeve back. Pull plug out of socket. (Gas is automatically shut off.)
2. Close shut-off valve and replace dust caps on socket and plug.
gas Requirements:
The RT2417S grill is set and tested at the factory for the type of gas supply to be used.
Identify the type of gas, either natural gas or LP gas, and make sure the marking on the rating
plate matches the gas supply. The rating plate is located on the inside panel of the door.
Plug
Fig. 23
21
Socket Sleeve
Sleeve
Socket
Lowes.com/masterforge
Fig. 24
Fig. 25