Radio Mode; Alarm Mode - Grundig Sonoclock 795 DCF Manual De Instrucciones

OPERATION
Switching on and off
1 Press » « to switch on the device
from standby mode.
2 Press » « to switch the device to
standby mode.

Radio mode

For the best possible FM (VHF) re-
ception, it is sufficient to align the
wire antenna accordingly.
Tuning to radio stations
1
Set the radio station by pressing and
holding down »
-«.
»
AL1/TUN
– The radio station search starts and
stops at the next station with a
good reception signal;
or keep pressing
or
»AL1/TUN-«
the frequency you want.
– Each time you press the button, the
frequency changes by 50 Hz
_____________________________________
« or
AL1/TUN+
»AL1/TUN+«
until you reach
Saving radio stations on
program-places
You can save this radio-program on
20 program places.
1 Set the radio station by pressing and
holding down »
-«.
»
AL1/TUN
– The radio station search starts and
stops at the next station with a
good reception signal;
or keep pressing
or
»AL1/TUN-«
the frequency you want.
– Each time you press the button, the
frequency changes by 50 Hz
2
Press » « longer.
SET
3
Select the program-place with
or
»PRESET+«
4
Confirm with »
Adjusting the volume
1
Adjust the volume by pressing
»HOUR/VOL+« or »MIN/VOL-«.

Alarm mode

The device has a dynamic alarm tone
that starts at a low volume and reach-
es its maximum volume within 30 to
45 seconds.
AL1/TUN+
»AL1/TUN+«
until you reach
»PRESET-«.
«.
SET
ENGLISH 23
« or