Heath Zenith 7396 Manual De Instrucciones página 2

2
A
ON
1 2
B
ON
1 2 3 4 5 6 7 8
1 2
C
ON
1 2
Figure 2
ON
1 2
Push Button
Setting
Figure 3
0
30 Sec.
Figure 4
Helpful Videos – www.hzsupport.com
• Push Button < A > (2 Switches): The push
button has only two switches similar to the
chime.
• Push Button < B > (1 Jumper): The push
button has a single jumper.
• Push Button < C > (7 or 8 Jumpers or
Switches): The push button has a row of 7
or 8 jumpers or switches.
4. Sync the push button and chime.
Syncing Push Button < A >
See Figure 3
• Set push button switch to ON.
• Press and hold the button on the chime
until the chime sounds a "Beep-Beep" (see
Figure 4).
• Press the push button within 30 seconds.
The chime will sound a "Beep-Beep" tone
to indicate the push button is synced (see
Figure 4).
• Press the push button to ensure operation.
• Go to step 5.
Syncing Push Button < B >
See Figure 4
• Press and hold the button on the chime until
the chime sounds a "Beep-Beep".
• Press the push button within 30 seconds.
The chime will sound a "Beep-Beep" tone
to indicate the push button is synced.
• Press the push button to ensure operation.
• Go to step 5.
Syncing Push Button < C >
See Figure 4
• Press and hold the button on the chime until
the chime sounds a "Beep-Beep".
• Press the push button within 30 seconds.
The chime will sound a "Beep-Beep" tone
to indicate the push button is synced.
• Press the push button to ensure operation.
• Go to step 5.
Helpful Answers – 1-800-858-8501