Heath Zenith 7396 Manual De Instrucciones página 6

6
3. PROBLEM: Chime sounds when not intended (false triggers).
POSSIBLE CAUSE: Chime is receiving interference from another wire-
less device.
CORRECTIVE ACTION: Reset chime.
• Remove push button battery. Wait 30 seconds.
• Press and hold the push button for 10 to 15 seconds within 60 seconds
after installing battery into the push button.
• Press and hold the button on the chime until the chime sounds a
"Beep-Beep-Beep-Beep".
• To re-sync the push button and chime, press and hold the button on
the chime until the chime sounds a "Beep-Beep".
• Press the push button within 30 seconds. The chime will sound a
"Beep-Beep" tone to indicate the push button is synced.
• Press the push button to ensure operation.
Note: The range of the wireless chime can vary with location, temperature,
and battery condition.
Helpful Videos – www.hzsupport.com Helpful Answers – 1-800-858-8501