Tools Required - Whittier Wood Furniture Hawthorne 77W Instrucciones

Phillips Head Screwdriver, Wood Glue, Rubber Mallet or Padded Hammer.
FIG. 1
1) Spread a thin layer of glue in the five holes in the top edge of the Lower Back (A). Insert the Back
Spindles (B) into the holes. Slip the Top Back (CC) down over the top of the back spindles. See
FIGURE 1. DO NOT GLUE THE BACK SPINDLES INTO THE TOP BACK (CC).
SHOULDER
E
D
FF
2) Lay the back assembly and the Back Stetcher (D) in their approximate positions between the Left Back
Leg (E) and the Right Back Leg (FF). THE CURVED TOP EDGE OF THE BACK LEGS SHOULD
FACE TOWARD THE FRONT OF THE CHAIR. THE LEFT BACK LEG (E) HAS A LARGER UP-
PER SLOTTED HOLE AND THE TOP BACK (CC) HAS A LARGER TENON ON THE LEFT SIDE.
Spread glue evenly in the two slotted holes in the Right Back Leg (FF). See FIGURE 2. Attach the
back assembly to the right back leg. Tap firmly into place. Now attach the Left Back Leg (E) to the back
assembly in the same manner.
To hold the back leg assembly together while the glue dries, use a piece of rope approximately five
feet long. Wrap the rope loosely around the back assembly midway between the backs (A & CC)
(protect the back legs with cardboard or cloth) and tie the ends in a square knot. Loop the rope around
a dowel or screwdriver and twist until tight. Tie down as shown in FIGURE 2A. It is important that
both backs are firmly and completely seated in the back legs and the shoulders of the backs are in
contact with the back legs. Leave rope in place at least one hour.
Insert a #8 x 1¼" Pan Head Screw (O) through the holes in the outside edge of each back leg into
the top back and fasten securely. See FIGURE 2A.
PAGE 4 — 77W
77 Hawthorne Chair
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

CC
B
A
B
A
O
2" LONG
CC
1¾" LONG
FIG. 2
IMPORTANT:
READ GLUING HINTS
BEFORE ASSEMBLING!
CC
A
D
FIG. 2A
O