GYS GYSDUCTION AUTO Manual Del Usuario página 14

Translation of the original instructions
14
GYSDUCTION AUTO
• People with metal implants should not use this machine.
• In case of burns, rinse with water abundantly and see a medi-
cal doctor as soon as possible.
Dangerosity of the gas fumes
• Keep the head away from the fumes, do not inhale.
• If working inside, ventilate the area or use a fume extractor to
evacuate the gases and fumes.
• Induction heating of certain materials such as adhesives and
flux can generate fumes and gases. Breathing these fumes and
gases can be dangerous for your health. For example, heating
urethane generates a gas : hydrogen cyanide, potentially mor-
tal for humans.
• If the ventilation is insufficent, use an approved respiratory unit.
• Read the safety data sheets (MSDS) and the manufacturer's ins-
tructions for adhesvies, flux, metals, consumables, coatings, clea-
ning agents, corrosives, and paint strippers.
• Do not use the heater on parts being degreased or sprayed. The
heat might react with fumes and generate highly toxic gases.
• Work in a confined area only if it's well ventilated, or use an ap-
proved repiratory/filtration unit. Make sure that a qualified per-
son is around to watch over you. The fumes and gases released
while heating can replace oxygen or air, causing accidents or
death. Check the quality of the air you're breathing
• Do not overheat metals, such as galvanised steel, covered with
lead or cadmium, unless the coating is removed from the surface
before it's heated, that the area is well ventilated, and if needed,
use an approved filtration/respiratory unit.. Foundry pieces and
all metals containing such elements may generates toxic fumes if
overheated. Check the MSDS for temperature related details.
Warning, electrical danger
Caution: Danger of optical radiation when the heated metal ele-
ments reach fusion.
Warning ! Major magnetic field. People wearing active or
passive implants must be informed.
No further protectective steps are required when the machine is
used on its own. Further restrictions and/or protective measures may
be necessary in other cases
After maintenance, the magnetic field levels must be checked
before the machine is used again.
When switched on, never put the inductor near the head or vital
organs.
People wearing pacemakers are advised to not come close to the
machine. Risk of disruption of pacemaker operations when close
to the machine. Consult a doctor before getting close to induction
heaters.
EN