RIB K 2007 Manual De Usario página 22

G
POINT A -
ELECTRIC CONNECTIONS
B
J1
AERIAL
J2
LSC
LSO
COM
PED BUTT
L-N
J3
J4 EARTH
J5 RADIO
J6 A+ TEST
A+
A-
COM +
K BUTT.
PHOT.
EDGE
-
J7
U - MOTOR
V-W - MOTOR
J8 PROBE
TRIMMER LOW SPEED
R1
R2 TRIMMER TORQUE
R1
R2 J1
DO NOT REMOVE ANY JUMPER!
OTHERWISE THE OPERATOR WILL NOT WORK!
Radio Antenna
Close limit-switch that cuts off the motor in closing
Open limit-switch that cuts off the motor in opening
Limit-switch common contact
Pedestrian opening contact (NO)
Main power supply 230 Vac 50/60 Hz (120V/60Hz upon request)
Connection of the earth line
Built-in radio module (model CRX),
or connector for radio receiver RIB, 24Vdc supply
24Vdc safety strip self-test power supply
Accessories power supply +24Vdc
Accessories power supply -24Vdc
Common contact (common line for all the command and safety inputs) (+)
Single pulse contact (NO)
Photocells contact (NC)
Safety strip contact (NC)
Buzzer contact (24Vdc max 200 mA) (-)
Flashing light (max 40W )
Motor common connection
Motor phase and capacitor connections
Temperature sensor cable connection PROBE (Code ACG4665 optional)
Electronic regulator for low speed on approach
Electronic torque regulator
J3 J4
J2 J5
22
J7
J6
J8