Introduction; Safety - Skymsen DC-06 Manual De Instrucciones

1. Introduction

1.1 Safety

When not properly used this equipment is a potentially dangerous machine. Maintenance,
servicing, cleaning or any other operation shall be made by trained people. Plug has to be
off outlet during any of these operations
Below instructions shall be respected to avoid accidents:
1.1.1 Read completely these instructions
1.1.2 To avoid to risk electric shocks and damage to the equipment never use it with wet
clothes or shoes and/or standing on wet floors. Do not plunge it into water nor any other
liquid, do not spray water directly to the equipment.
1.1.3 When the equipment is in operation the operator shall supervise it, principally when
children might be near
1.1.4 Unplug the equipment when :
It is not in use, before to clean it, before to remove or to place some accessory. Before
maintenance or any other service.
1.1.5 Do not operate the equipment if the cord or plug are damaged. Do not lean the cord
on table edges, nor let them lie on hot surfaces.
1.1.6 When the equipment may have fall, have been damaged any way, or simply does not
work, take it to Technical Assistance to check.
1.1.7 The use of accessories not recommended by the manufacturer may cause corporal
damages.
1.1.8 Keep the hands or any other object away from moving parts while the equipment is
in operation.
1.1.9 During operation never wear loose clothes with wide sleeves principally around the
wrists.
1.1.10 Make sure the equipment voltage and the network voltage are the same, and the
equipment has been solidly grounded.
1.1.11 When placing the Disc #.08 (Pic.01) make sure its perfect fitting on Central Shaft Pin
# 02 (Pic. 02) avoiding to damage the equipment.
3