Electric Installation; Hydraulic Installation - Skymsen DC-06 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.1.2 Electric Installation

This equipment has been designed for 110 or 220 V, When receiving the equipment check
the voltage indicated on the cord label. Next, adjust the voltage of the machine that must
be the same as the main voltage, using the Voltage Selector Switch No. 10 (Fig.01) located
on the bottom of the machine.
The cord has a plug with three pins, the middle one is ground. It is mandatory the three
pins to be duly connected before to start the machine.
Make sure the network voltage is the same as the voltage indicated on the cord

2.1.3 Hydraulic Installation

It is recommended to install the machine near a drain or channel the water outlet, through
an extension of the Water Outlet No. 03 (Fig.01). It is also necessary to install a faucet
(diameter ¾) with tap water directly on the product to be stripped. Alternatively, it is
possible to pick up water from another faucet through a hose.
NIPPLE
Water entrance to be
connected to the Nipple.
WATER EXIT PIPE
For water and residues.
Install the machine near a
water sink.
The water outflow jet shall not drop beyond the disc centre as shown on Picture 04.
The water outflow shall not exceed 2.5 litres per minute.
IMPORTANT
label.
PICTURE 03
PRODUCT ENTRANCE
It is mandatory to let
water flow directly on the
product
7

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido